The virtio-blk device is a simple virtual block device. The FE driver (in the User VM space) places read, write, and other requests onto the virtqueue, so that the BE driver (in the Service VM space) can process them accordingly. Communication between the FE and BE is based on the virtio kick and notify mechanism.
The virtio device ID of the virtio-blk is
2, and it supports one
virtqueue, the size of which is 64, configurable in the source code.
The feature bits supported by the BE device are shown as follows:
Maximum number of segments in a request is in seg_max.
Block size of disk is in blk_size.
Device exports information on optimal I/O alignment.
Support for indirect descriptors
Cache flush command support.
Device can toggle its cache between writeback and writethrough modes.
Virtio-BLK BE Design¶
The virtio-blk BE device is implemented as a legacy virtio device. Its backend media could be a file or a partition. The virtio-blk device supports writeback and writethrough cache mode. In writeback mode, virtio-blk has good write and read performance. To be safer, writethrough is set as the default mode, as it can make sure every write operation queued to the virtio-blk FE driver layer is submitted to hardware storage.
During initialization, virtio-blk will allocate 64 ioreq buffers in a shared ring used to store the I/O requests. The freeq, busyq, and pendq shown in Figure 273 are used to manage requests. Each virtio-blk device starts 8 worker threads to process request asynchronously.
The device model configuration command syntax for virtio-blk is:
b: when using
vsblas the virtual bootloader, use this immediately after
virtio-blkto specify it as a bootable device and the bootable image location.
filepathis the path of a file or disk partition
writethru: write operation is reported completed only when the data has been written to physical storage.
writeback: write operation is reported completed when data is placed in the page cache. Needs to be flushed to the physical storage.
ro: open file with readonly mode.
sectorsize: configured as either
sectorsize=<sector size>/<physical sector size>or
sectorsize=<sector size>. The default values for sector size and physical sector size are 512
range: configured as
range=<start lba in file>/<sub file size>meaning the virtio-blk will only access part of the file, from the
<start lba in file>to
<start lba in file> + <sub file site>.
A simple example for virtio-blk:
Prepare a file in Service VM folder:
dd if=/dev/zero of=test.img bs=1M count=1024 mkfs.ext4 test.img
Add virtio-blk in the DM cmdline, slot number should not duplicate another device:
Launch User VM, you can find
/dev/vdxin User VM.
/dev/vdxis related to the slot number used. If If you start DM with two virtio-blks, and the slot numbers are 9 and 10, then, the device with slot 9 will be recognized as
/dev/vda, and the device with slot 10 will be
/dev/vdxto a folder in the User VM, and then you can access it.
Successful booting of the User VM verifies the correctness of the device.